![]() ![]() ![]() I see that it supports Apple filesystems now. It was easy to use, it handled both the drive imaging, and the file recovery, and trial mode let me figure out how much data it could recover before I decided to pay for it. I haven't used it in years, but I used r-studio to recover data from an NTFS disk. ![]() You can probably find software that combines the two. I don't know what to recommend for the software to extract the data from the corrupted file system. If it were me, I'd use ddrescue to do the drive imaging, but its a command line tool, and maybe not your speed. Then you need software that can try and recover data from (likely) corrupted filesystems. It could take many days before it's done its best. You need some data recovery software that goes through your bad drive, block by block trying to recover data and writing it to a disk image. If a new USB-SATA controller doesn't work, then the next thing is that you need hard disk space, at least as much as your dead hard drive can hold. If it's the latter, you should get another USB-SATA adapter and see if the drive works properly with it. You might be able to recover data, but the more time you spend messing around, the less likely it is that you are going to get any of it back.įirst step is removing the drive from the case in order to determine whether it uses a USB-native disk controller, or whether there it is a SATA drive with a USB to SATA adapter. Don't let this moment go to waste Get serious about backups because this is going to happen to you again. Step 1: Open Device Manager as mentioned in Method 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |